Skip to content
Call (651) 410-5001

Power Out, Breakers Tripping or a Burning Smell: What to Do

Safe first steps for urgent electrical problems at home, and how to tell whether 911, the utility or an electrician should get the call.

When to Leave and Call 911

Get everyone out of the building first, then call 911, if you notice any of these:

  • Smoke, flames or sparks from an outlet, switch, light fixture, appliance or the panel
  • A burning or hot-plastic smell, especially one you can’t trace or that keeps getting stronger
  • Water near the panel, outlets or cords, as in a flooded basement; don’t step into it
  • A power line down outside, or wires sparking where they meet the house

Don’t stop to switch off breakers or unplug things on the way out, and stay well away from a fallen line and anything it touches.

Most electrical trouble at home is not a fire. A breaker trips, a room goes dark, half the lights dim, or an outlet feels warm. A few safe checks usually show whether the problem is inside the house, at the utility or serious enough for 911.

When the problem is inside the house, call us at (651) 410-5001 and describe what you saw and what you have already tried.

Find the Safe First Step for What You See

Pick the symptom closest to yours for the steps that are safe to take now and who should get the first call.

Outage, Breaker and Outlet Troubleshooter

What is happening?

Pick a symptom, then press Show What to Do.

Do and Don’t Until It Is Fixed

A few habits keep an outage or a tripping breaker from turning into something worse.

Do

  • Keep a flashlight near the panel, and use flashlights rather than candles in an outage
  • Know which breaker in the panel is the main
  • Keep the space in front of the panel clear
  • Unplug electronics in an outage and leave one lamp on to show when power returns
  • Reset a tripped breaker once, by pushing it fully off and then back on

Don’t

  • Don’t touch the panel, outlets or cords while standing on a wet floor
  • Don’t reset a breaker again and again, hold it on or tape it in place
  • Don’t replace a fuse or a breaker with a larger one
  • Don’t take the panel cover off or try a repair inside it
  • Don’t go near a fallen line or anything it touches, such as a fence or a puddle

Symptoms, Likely Causes and Who to Call

SymptomLikely causeWhat to do nowWho to call
Whole house dark, and the neighbors tooA utility outageUnplug electronics, keep the fridge closed and report the outageThe utility
Only your house is darkA tripped main breaker, or trouble at the meter or the incoming wiresReset the main breaker once if it has tripped; leave the meter aloneThe utility if the main is on; an electrician if it trips again
Half the house dark, or lights oddly bright or dimA lost leg of the service or a loose neutralSwitch off large appliances and unplug electronicsThe utility first; an electrician if its side checks out
One room or a few outlets deadA tripped breaker or GFCI outlet, or a loose connectionReset the breaker once and press Reset on nearby GFCI outletsAn electrician if the power stays off
A breaker that trips right after a resetAn overloaded circuit, or a short or ground faultUnplug everything on it and reset once; if it still trips, leave it offAn electrician
A warm, buzzing or discolored outlet or switchA loose or failing connection or a worn deviceSwitch off its breaker and stop using itAn electrician, or 911 if there is smoke or a burning smell
One light that flickersA loose bulb, a failing fixture or a worn switchTighten or replace the bulb once it has cooledAn electrician if a good bulb still flickers
Wires or the mast pulled loose in a stormStorm damage at the service entranceStay well back and keep others away911 if a line is down or sparking, then the utility

Why does my breaker keep tripping?

A breaker trips to protect the wiring, either because the circuit is carrying more than it is rated for or because current is escaping through a short or a ground fault. Tripping a while after a heater or a microwave starts points to overload; tripping the instant you reset it points to a fault. An old breaker can also wear out, but the answer is never a larger breaker.

Half the house lost power but the rest still works. What does that mean?

Most homes get two 120-volt legs from the utility, and the panel splits its circuits between them. Lose one leg and about half the circuits go dark, along with 240-volt appliances like the dryer. Lights that are also brighter or dimmer than normal suggest a loose neutral, which can damage electronics: unplug them and call the utility first.

A summer storm pulled the wires loose from our house. Who do we call?

Stay away from the wires and anything they touch, and call 911 if a line is down, sparking or burning. The utility handles its lines and the meter and will cut power if the connection is unsafe. A bent or torn mast or meter socket on the house is usually the owner’s to have repaired by an electrician, and the utility typically reconnects once the repair has been inspected.

Utility or Electrician: Who Gets the First Call

Trouble that reaches past your house, or comes in with the power itself, starts with your utility, Xcel Energy in most of the area. Trouble that stays on one circuit or behind one outlet is an electrician’s.

Some problems need both: after storm damage, the utility makes its lines safe and an electrician repairs the house’s side before the power is restored. Who looks after the meter and the service wires day to day is covered under electrical services.

Should I call the utility or an electrician first?

Make two checks. If the neighbors are dark too, or only your house is dark while its main breaker is still on, call the utility. If the main breaker has tripped, or the outage is one room or one circuit, call an electrician. When you can’t tell, the utility can say whether its equipment is involved.

What should I tell the electrician when I call?

Say what happened and when: what went dark or tripped, what was running at the time, and anything you smelled or heard. Mention what you have already tried, such as resetting a breaker or a GFCI outlet, and whether the house has breakers or fuses. In winter, say if the furnace or a sump pump is on the dead circuit, because that changes how soon it needs attention.

Once everyone is safe and the affected circuit is off, call and describe what you saw.